Rimage AutoPrinter Guía de usuario descargar pdf (Pagina 16)

Rimage AutoPrinter

10 110656_H

b. If the disc is not centered on the print

pad, align the printer side to side.

i. Using the T25 Torx screwdriver,

loosen the two side to side

alignment screws.

ii. Slide the printer, not the printer

tray, until the side edges of the

disc and printer pad are aligned.

iii. Tighten the two side to side

alignment screws.

c. Using either a T25 Torx driver or a

5/32” Allen wrench, turn the front to

back alignment screw until the disc

hangs over the edge of the print pad by

0.010” – 0.015” (0.25mm – 0.38mm).

Side to Side Alignment Screws

Front to Back

Alignment Screw

Print Pad

5. When the printer is aligned, slide the lift arm to the top the unit.

6. Press the printer button to close the printer tray.

7. Press the disc release button to release the disc from the gripper.

# Tip: Place your hand under the disc to catch it.

1 2 ... 11 12 13 14 15 16 17 18 19 20

Sin comentarios

Rimage AutoPrinter Guía de usuario Pagina 16