Rimage PrismPlus! Guía de usuario

Rimage AutoPrinter IITM User Guide

Rimage AutoPrinter II Lift arm parts This is the bottom view of the lift arm assembly. Gripper Hub The Gripper Hub holds the disc in place while the

Operate the AutoPrinter II Operate the AutoPrinter II Installing the carousel You may load discs in the bins before installing the carousel. -Impor

Rimage AutoPrinter II   Installing ribbons To install ribbons in the printer, stop any operations. To change ribbons in a Prism printer, refer to t

Operate the AutoPrinter II Aligning the Everest II printer After installing the printer, or if discs are not placed on the printer properly, the prin

Rimage AutoPrinter II b. If the disc is not centered on the print pad, loosen the two Side to Side Alignment Screws. c. Slide the printer, NOT the

Operate the AutoPrinter II b. To place a disc in the Gripper, press the disc up into the Gripper while pressing the Disc Release Button. c. Release

Rimage AutoPrinter II  4. To perform the front to back alignment procedure, turn the Front to Back Alignment Screw until the disc hangs over the fr

Learn More Learn More AutoPrinter II Specifications Standard System AutoPrinter autoloader, a Rimage Everest II or Prism printer, and CD Designer sof

Rimage AutoPrinter II -ppTechnical support and product updates Important! Register your Rimage AutoPrinter II online or complete and return the re

Learn More 110656_G 13 Rimage AutoPrinter Limited 1 Year Warranty Rimage warrants, to the original end user only, that all non-consumable parts of

Corporate Headquarters: Rimage Corporation 7725 Washington Avenue South Minneapolis, MN 55439 USA 800 553 8312 (toll free US) Service: +1 952 946 00

Rimage AutoPrinter II Support information US, Asia/Pacific, Mexico/Latin America Europe Rimage Corporation 7725 Washington Avenue South Minneapolis,

Contents Contents Introduction ... 1 Identify AutoPrinter II parts

Rimage AutoPrinter II ii

Introduction Introduction Rimage offers two Producer II AutoPrinters: the AutoEverest and the AutoPrism. The primary difference between the two is th

Rimage AutoPrinter II Identify AutoPrinter II parts Front view AutoEverest AutoPrism Rear view AutoEverest AutoPrism Power switch The power switch

Identify AutoPrinter II parts Operator panel The Operator panel has four LEDs (Light-Emitting Diodes) and an Operator Button. Operator Button Each t